--- title: "Commission a MicronLevel Air Sensor" canonical: "https://farmconnect.docs.rubiconwater.com/space/BY/2330066977/Commission%20a%20MicronLevel%20Air%20Sensor" format: markdown --- > ℹ️ **Note** > ℹ️ > ℹ️ The settings and data units depend on your browser language. Ensure that you have selected English (Australia) to display as metric, or English (United States) to display as Imperial. **Step 1** [Reconnect to the FerIT Solar Node](https://rubiconwater.atlassian.net/wiki/spaces/BY/pages/1961164896/Commissioning+and+Configuration#Connect-to-the-FerIT-SolarNode) and [open the Micron Level driver](https://rubiconwater.atlassian.net/wiki/spaces/DC/pages/1914896447/Viewing+and+Managing+Devices#View-and-Modify-Driver-Settings-and-Data) from the **Drivers** tab. Then select the **Diagnostic** tab. **Step 2** Confirm that the FerIT Solar Node is communicating with the sensor by checking the **Comms Status** field **Step 3** Configure the ‘Device Datum’: With a tape measure, measure down from the face of the level sensor to the ground. Enter this value in the **Device Datum** field so that the displayed measurement value is in reference to the ground. **Video: Calibrating Water Level to Ground** > Macro (excerpt) > > ![RUB_Tutorial_FC-DeviceConnect Calibrate Water Level to Ground.mp4](media://04875f34-14c3-41b8-bc48-a8243525ec42)
Calibrating Water Level to Ground ![RUB_Tutorial_FC-DeviceConnect Calibrate Water Level to Ground.mp4](media://04875f34-14c3-41b8-bc48-a8243525ec42)
**Step 4** Go to the **Settings** tab. Configure ‘Change of State’ bursting: If **CoS Bursting** is set to ENABLED, any change in measurement greater than the **CoS Value** will trigger a burst of data back to the host system. This is recommended if using the level sensor for [https://rubiconwater.atlassian.net/wiki/spaces/FCD/pages/2029586433](https://rubiconwater.atlassian.net/wiki/spaces/FCD/pages/2029586433). **Step 5** Configure ‘Percentage Full’ parameters: if measurement of the water level as a percentage of full is required, configure the **Custom Range Minimum **by entering the measurement equivalent to 0% full and configure the **Custom Range Maximum** by entering the measurement equivalent to 100% full. The percentage full will be calculated in this measurement range. **Video: Configure Water Level % Full Feature**
Configure Water Level % Full Feature ![image](media://5e14b7bb-121a-4059-9d7e-074021d6ae68)
> Macro (excerpt) > > ![image](media://5e14b7bb-121a-4059-9d7e-074021d6ae68) The MicronLevel Air Sensor is now fully commissioned and configured. ---